As part of the Long Term Ecological Research (LTER) project in the McMurdo Dry Valleys of Antarctica, a systematic sampling program has been undertaken to monitor mass balance and meltwater flow from the Taylor Valley glaciers. This dataset contains mass balance changes at each stake measured on the glaciers of Taylor Valley. The values are the result of an analysis of the raw data presented in other data files (glacier stake heights and snow depths, and glacier snow densities). Included here for each stake is the total water equivalent mass change. The standard deviation or the range for each total is given.
...or query the dataset by variables and dates of interest:
The goal of each summer season is to take measurements in early spring (Oct/Nov) and late summer (late January). This provides a measure of seasonal winter/summer changes of glacier mass.
The methods of data collection are described in the glacier stake heights, snow depths and glacier snow density metadata files. To convert the data to mass values, the total change in ice height (usually negative) and snow height (depth for snow covered ice) at each stake are multiplied by their respective densities. The density for ice is 0.9 g/cm3 and the density for snow is measured in nearby snowpits. The final error of the mass balance measurement is based on the errors in the stake heights and snow depths found by replicated measurements. The errors were carried through the calculations based on Baird, D.C., 1962. Experimentation: An Introduction to Measurement Theory and Experiment Design. Prentice Hall, Englewood. We assume no error in the snow density measurements. A Note about Stake names A stake with an H or V indicates a stake along the ice cliff that forms the boundary of the glacier terminus. An H is a horizontal stake placed into the vertical wall of the glacier terminus, and V is a stake placed into the ice apron at the base of the ice cliff. The vertical stakes were installed to support the horizontal stakes and provide a nearby measure of ablation for a surface with a much different slope. A Note about Standard Deviation Calculations: During the early years only one or two measurements of surface height were taken at each stake. If two measurements were taken, the average was used and the range expressed as the error; note of this was made in "comments" field. If greater than 2 measurements of surface height and snow depth were taken, standard deviation of Total WEQ Change was based on a calculation of errors.
In some circumstances we have the opportunity or need to measure the glaciers in mid-season (Dec). View the dates the measurements were made at the following URL: